LiFePo4 battery 12V 6Ah (4s1p)

The rechargeable battery (ACB) is designed for stable output of high capacity during repeated deep charge-discharge cycles in electrical systems with a constant voltage of 12V. For safe operation, monitoring and control, the battery is equipped with a BMS (Battery Management System). The BMS system provides: passive balancing of cells, control of charging and discharging conditions (by voltage and current), temperature control.

Specifications:

• Rated voltage: 12.8V;
• Rated capacity: 6Ah;
• Case form factor: AGM 4Ah-5.5Ah;
• Maximum charge voltage: 14.6V
• Maximum charge current: 5A;
• Maximum discharge voltage: 10V;
• Maximum discharge current: 20A;
• Cell type: LiFePo4 32700;
• Element Diagram: 4S31;
• BMS type: 3S 25A passively balanced or active balanced;
• Additional charger connector: 5.5x2.1;
• Charge status indicator: no;
• Additional outputs: no;
• Material: ABS plastic;
• Size: 90x70x100 mm;
• Weight: 660 g.

Operating features:

• When charging the battery, connect the charger connector to the battery first and then to the AC outlet;
• After the battery is fully charged, turn off the AC power and then disconnect the battery.
• If you first disconnect the battery pack from the charger during charging, especially when the charging current is high (red light), the charger can be easily damaged.
• When the charger's LED indicator turns green, continue charging for 2-3 hours to balance the battery cells.
• Please use the charger and battery in a dry place, avoid overheating and hypothermia.
• Please try not to charge the battery immediately after the battery is depleted. Let it cool down.
• Please do not charge the battery while it is being discharged. Otherwise, you risk damaging the battery.
• Do not discharge the battery below the discharge voltage limit specified for the specific battery.
• If you need to store the battery for a long time, leave the battery 40-50% charged.
• Please do not use Li-Ion batteries in lead-acid UPS/Inverters without deep modification of the latter. Use a LiFePo4 battery and there will be little modification to the UPS/Inverters.