Height only 100mm, weight less than 290g, easy to carry.

Large size PTT button and double handle design on the top make it easy to operate.

Traditional digital-to-analogue compatibility allows the PH600 to quickly switch between digital and analog modes.

The front speaker and high-performance amplifier provide loud and clear sound even in noisy environments.

The standard 2600 mAh battery supports up to 20 hours of operation with a 5-5-90 duty cycle in normal DMR mode.

IP68 and MIL-STD 810G rated, resistant to water, extreme weather, drops and shock at various levels.

Support for 40-bit basic encryption. 128/256-bit AES encryption can be purchased separately. Simple software settings ensure that the call is reliable.

Supports multiple dispatch services such as logging, radio checking, solo operation, and remote stunning/recovery to realize remote dispatching and meet daily work management needs.

Voice prompt informs users immediately about news and information.

In addition to basic DMR voice and data services, the PH600 also supports many advanced features such as GPS, Bluetooth, voice recording, advanced encryption, ECS at an additional cost.

General:

  • Digital Protocol: ETSI TS 102 361-1,-2,-3 (-4 is optional)
  • Frequency: UHF1: 400-470MHz  UHF3: 350-400MHz  VHF: 136-174MHz
  • Channel Capacity: 32
  • Zone Capacity: 2 (Up to 16 Groups per Zone)
  • Channel Spacing: 12.5kHz/20KHz/25KHz
  • Frequency Stability: ±0.5ppm
  • Operating Voltage: 7.4V
  • Battery Capacity: 2600mAh (Standard)
  • Battery Life(5:5:90): Analog: 16 hours, Digital: 20hours
  • Size (H x W x D): 100*54.5*37.5mm (without antenna)
  • Weight: About 270g (With Antenna and Battery)
  • Voice Announcement: Support
  • Vocoder: AMBE++
  • VOX: Support
  • Man Down: Support
  • Vibration: Support
  • Optional Board: Support
  • Recording: Support (Optional)
  • Bluetooth: Built-in BT4.0 Chip Supports BT Audio/PTT/Positioning Device (Optional)
  • Location: GPS (Optional)
  • Encryption: Support SW and HW Encryption ( Optional )

Receiver:

  • Sensitivity(Analog Typical): 0.18uV(12dB SINAD)
  • Sensitivity(Digital Typical): 0.18uV (5% BER)
  • Adjacent Channel Selectivity: 60 dB@12.5KHz/70 dB@20/25KHz (TIA603A) -1T, 45dB@12.5KHz /70 dB@20/25KHz (TIA603D) -2T, 60dB@12.5KHz /70 dB@20/25KHz ( ETSI )
  • Intermodulation: 70 dB (TIA603D), 65 dB (ETSI)
  • Spurious Rejection: 70 dB (TIA603D), 70 dB (ETSI)
  • Blocking or Desensitization: 80dB(TIA603D), 84dB(ETSI)
  • Co-channel Rejection: -12~0 dB @12.5KHz/-8~0 dB @20/25KHz
  • Hum and Noise: -40 dB@12.5KHz /-43 dB@20KHz /-45 dB@25KHz
  • Rated Audio Power: 0.5W
  • Max Audio Power: 2.0W
  • Audio Distortion @ Rated Audio: ≤3% (Typical)
  • Audio Response: +1~-3dB (TIA603D)
  • Conducted Spurious Emission: -57 dBm (TIA603D)

Transmitter:

  • Low Power Output: 1W
  • High Power Output: 4W (UHF1) / 5W (VHF)
  • FM Modulation: 12.5KHz: 11K0F3E / 20KHz: 14K0F3E / 25KHz: 16K0F3E
  • 4FSK Digital Modulation: 12.5KHz Data Only: 7K60F1D&7K60FXD, 12.5KHz Voice Only: 7K60F1E&7K60FXE, 12.5KHz Voice And Data: 7K60F1W
  • Conducted/Radiated Emission: -36dBm ≤1GHz ; -30dBm >1GHz
  • Modulation Limiting: ±2.5KHz @12.5KHz /±4KHz @20KHz /±5.0KHz @25KHz
  • FM Hum and Noise: -40 dB@12.5KHz /-43dB@20KHz /-45 dB@25KHz
  • Adjacent Channel Power: 60 dB@12.5KHz /70 dB @20/25KHz
  • Audio Distortion @ Rated Audio: ≤3% (Typical)
  • Audio Response: +1~-3dB(TIA603D)

Environmental:

  • Operating Temperature: -30C ~ +60C
  • Storage Temperature: -40C ~ +85C
  • ESD: IEC 61000-4-2 (level 4) ±8kV (Contact) ±15kV(Air)
  • Dust and Water Resistance: IP68
  • Reliability: MIL-STD-810 G

GPS:

  • Accuracy specs are for long-term tracking (95th percentile values>5satellites visible at nominal -130 dBm signal strength)
  • TTFF (Time To First Fix) - Cold Start: <60s
  • TTFF (Time To First Fix) - Hot Start: <10s
  • Horizontal Accuracy: <10m

Radio specifications
Standards and frequencies
  • UHF1: 400-470 MHz UHF3: 350-400 MHz
  • VHF: 136 - 174 MHz;
  • Number of channels: 32;
  • Bluetooth: Built-in BT4.0 chip supports BT Audio/PTT/positioning device (optional)
  • Power supply voltage: 7.4V
  • Geolocation: GPS
Basic technical characteristics
  • Digital protocol: ETSI TS 102 361-1,-2,-3 (-4 optional)
  • Frequency: UHF1: 400-470MHz UHF3: 350-400MHz VHF: 136-174MHz
  • Channel capacity: 32
  • Zone capacity: 2 (up to 16 groups per zone)
  • Channel spacing: 12.5 kHz/20 kHz/25 kHz
  • Frequency stability: ±0.5ppm
  • Operating voltage: 7.4V
  • Battery capacity: 2600 mAh (typical)
  • Battery life (5:5:90): analog: 16 hours, digital: 20 hours
  • Size (H x W x D): 100*54.5*37.5mm (excluding antenna)
  • Weight: approx. 270 g (with antenna and battery)
  • Voice Announcement: Support
  • Vocoder: AMBE++
  • Voice: Support
  • Man Down: Support
  • Vibration: Support
  • Additional fee: Support
  • Record: support (optional)
  • Bluetooth: Built-in BT4.0 chip supports BT Audio/PTT/positioning device (optional)
  • Location: GPS (optional)
  • Encryption: support for software and hardware encryption (optional)
Receiver
  • Sensitivity (analog typical): 0.18 μV (12 dB SINAD)
  • Sensitivity (digital typical): 0.18 µV (5% BER)
  • Adjacent channel selectivity: 60 dB @ 12.5 kHz / 70 dB @ 20/25 kHz (TIA603A) -1T, 45 dB @ 12.5 kHz / 70 dB @ 20/25 kHz (TIA603D) -2T, 60 dB @ 12.5 kHz / 70 dB @ 20/25 kHz (ETSI)
  • Intermodulation: 70 dB (TIA603D), 65 dB (ETSI)
  • Spurious rejection: 70 dB (TIA603D), 70 dB (ETSI)
  • Block or desensitize: 80 dB (TIA603D), 84 dB (ETSI)
  • Co-Channel Rejection: -12~0dB@12.5kHz/-8~0dB@20/25kHz
  • Hum and noise: -40 dB @ 12.5 kHz / -43 dB @ 20 kHz / -45 dB @ 25 kHz
  • Rated sound power: 0.5W
  • Maximum sound power: 2.0W
  • Audio distortion at nominal audio: ≤3% (typical)
  • Audio response: +1 ~ -3 dB (TIA603D)
  • Conducted Spurious Emission: -57 dBm (TIA603D)
Transmitter
  • Low power output: 1W
  • High power output: 4W (UHF1) / 5W (VHF)
  • FM modulation: 12.5 kHz: 11K0F3E / 20 kHz: 14K0F3E / 25 kHz: 16K0F3E
  • 4FSK digital modulation: 12.5 kHz data only: 7K60F1D and 7K60FXD, 12.5 kHz voice only: 7K60F1E and 7K60FXE, 12.5 kHz voice and data: 7K60F1W
  • Conducted/radiated emissions: -36 dBm ≤1 GHz; -30dBm>1GHz
  • Modulation limit: ± 2.5 kHz at 12.5 kHz / ± 4 kHz at 20 kHz / ± 5.0 kHz at 25 kHz
  • FM hum and noise: -40 dB @ 12.5 kHz / -43 dB @ 20 kHz / -45 dB @ 25 kHz
  • Adjacent channel power: 60 dB @ 12.5 kHz / 70 dB @ 20/25 kHz
  • Audio distortion at nominal audio: ≤3% (typical)
  • Audio response: +1 ~ -3 dB (TIA603D)
Operating conditions
  • Operating temperature: -30C ~ +60C
  • Storage temperature: -40C ~ +85C
  • ESD: IEC 61000-4-2 (level 4) ±8 kV (contact) ±15 kV (air)
  • Dust and water resistant: IP68
  • Reliability: MIL-STD-810G
Operating conditions
  • Radio: 1pc
  • Battery: 1pc
  • Charger: 1pc
  • Clip: 1pc
  • Operating manual: 1pc

Write a review

Note: HTML is not translated!
    Bad           Good

Caltta PH600 VHF radio

  • Brand: Caltta Technologies Co.
  • Product Code: Caltta PH600 VHF
  • Weight: 270.00g
  • Dimension: Д: 100.00mm  х  Ш: 54.50mm  x  В: 37.50mm
  • SKU: Caltta PH600 VHF
  • Availability: In Stock
  • Already bought: 0 in
  • 328.82 €

Equipment:



View: 184

Related Products

Caltta PH690 UHF

Caltta PH690 UHF

The analog and digital modes of operation allow the radio to be used in mixed radio fleets and gradu..

501.02 €

Caltta PH690 VHF

Caltta PH690 VHF

The analog and digital modes of operation allow the radio to be used in mixed radio fleets and gradu..

Out Of Stock

501.02 €

Caltta PH660 UHF

Caltta PH660 UHF

Caltta PH660 is a DMR Tier 2 portable digital radio operating in the 400-470 MHz VHF band, equipped ..

379.41 €

Caltta PH660 VHF

Caltta PH660 VHF

Caltta PH660 is a DMR Tier 2 portable digital radio operating in the 400-470 MHz VHF band, equipped ..

379.41 €

Caltta PR900 U1 UHF DMR

Caltta PR900 U1 UHF DMR

DMR conventional communication repeater Caltta PR900 U1 UHF DMR Features: Supports DMR Tier 2 ..

New

2,569.88 €

Tags: Caltta PH600 VHF

Featured Articles

POC radio communication

POC radio communication

POC - is a PTT (Push-to-talk) call over the cellular network. In other words, it is a technology that uses a broadband cellular network and a broadband WiFi network to build a network and organize com..

Unlicensed radio communication

Unlicensed radio communication

Unlicensed radio communication Unlicensed radio communication refers to radio communication that takes place on frequencies whose use does not require a special license or permit. In accordance ..

Licensed (commercial) radio communication

Licensed (commercial) radio communication

Licensed radio communication Licensed radio communication refers to radio communication that takes place on frequencies whose use requires a special license or permit. Licensed radio communications..

Building a radio network

Building a radio network

Radio network types The choice of the type of radio network is determined by the available frequency resource, the number of users and the specifics of their work. The most common is the convention..